|
Qmark MUH0521 Electric Shop Unit Heater - Ships from the Factory in South Carolina Heavy gauge die-formed steel housing. Two-toned, smartly styled.
Advanced pull-through air flow design draws air across heating element for more even air distribution and cooler element operation.
Specially designed venturi outlet to meet that added throw as required in vertical position.
Completely enclosed fan motor.
Aluminum-finned, copper clad steel sheath heating element has longer useful life, because of cooler sheath temperature and faster heat dissipation.
Automatic reset linear thermal cut-out, capillary type, provides protection over entire length of element areas.
Ruggedly built, yet lighter weight for easier installation. No piping flues, valves, or traps.
Individually adjustable discharge louvers to control air flow.
The Qmark MUH0521 meets all UL, NEC, and OSHA requirements. UL Listed Limited 1 Year for the Unit, and 5 Year warranty on Element Quick Specs for Qmark MUH0521 Off White Finish 350 CFM (Air flow) 27 Lbs 5,000 watts (17,065 BTU's) 240 volts 1 - 3 phase hard wired 21.0 Amps 1/100 Motor HP
10 AWG Wire Size OPTIONAL Voltage 3,700 watts (12,600 BTU's) 208 volts 1 - 3 phase hard wired 18.0 Amps 1/100 Motor HP
10 AWG Wire Size Heater Dimensions 14 W 16 H 7 1/2 D Optional Accessories for the MUH0521: (Sold Separately)
Thermostats:
Built-In Thermostat - Double Pole Internal Thermostat Field Installed Temp. Range: 40°F - 85°F = MT-2
Wall Thermostat (Beige Finish) (Line Voltage 240 Volt ) Two Stage Double Pole Wall Mount Thermostat Temp. Range: 45°F - 75°F = M600S
Mounting Bracket:
Universal Wall & Ceiling Bracket - MMB10
Disconnect Switch:
Power Disconnect Switch - MPDS25
Installation: To prevent a possible fire, do not block air intakes or exhaust in any manner. Keep combustible materials, such as crates, drapes, etc., away from heater. Do not install behind door, furniture, towels, or boxes. This heater is not approved for use in corrosive atmospheres such as marine, green house or chemical storage areas. The heater should be installed out of traffic areas and at least 7' off the floor.
Related Categories
|
