Qmark BRH482 Portable Electric Construction Heaters
A truly portable heater that is big on performance
Sturdy handle for portability that also serves as cord rack.
6 ft. 12 Awg. molded cable with grounded, 250 volt plug.
Plug Type 30 Amp 240v NEMA #6-30P
Receptacle 30 Amp 240v NEMA #6-30R- Not Included
Thermal protection with automatic reset.
Permanently lubricated motor.
Continuous fan feature.
Powder-coated epoxy finish is long lasting and corrosion resistant
Limited 5 Year warranty on Element or Motor
4,800 watts (16,380 BTU's)
240 Volts hard wired
10 1/2 W
11 H Plus handle
Includes 6 foot cord with a NEMA standard plug (6-30P)
Double pole thermostat is built-in
Keep at least 8 inches between the unit and any adjacent surfaces (walls and ceilings).
This heater is not suitable for use in wet or very humid locations.
Continuous Fan Operation
To activate the continuous fan feature, set rocker switch to ON position. The elements will continue to cycle on the thermostat setting. For no heat, turn thermostat to full counterclockwise position. With fan in AUTO position, fan will cycle with the thermostat.
Set the thermostat to the farthest clockwise position. The fan should come on and the unit will start heating the room. When the room reaches comfort level, turn the thermostat counterclockwise until the heater turns off. The heater will cycle automatically around this preset temperature. To increase temperature, turn the thermostat knob clockwise. To lower temperature, turn the thermostat counterclockwise.